Our Drop Cables are designed for quick and easy connection of end-users to a nearby Fiber Access Terminal (FAT) in the FTTx network.
Drop cables can be a good alternative for shorter distances and where there is easy access for the cable installation. To facilitate installation and minimize attenuation when the cable is installed around sharp corners, all ourdrop cables are based on extra bend resistant G.657A" fiber.
Drop cables for underground installations, loose tube, TOL 406 9001+
The drop cable based on loose tube technology, Two Fiber reinforced plastic rods (FRP) ensures high tensile performance. The black PE sheath gives the cable good protection against all outdoor environments.
Drop cables for aerial installations, loose tube fig-8, TOL 406 9002+
The drop cable is of fig-8 design with a loose tube and a steel strength member. The black PE sheath is UV stabilized to withstand aerial installations.
Drop cable for indoor use, tight protected, extra slim 2.9 mm, TOL 406 3005/1A
This extra slim drop cable is intended for installations in existing pipes or cable channels. It has a low friction coating to allow for easy installation by pulling. The fire resistance is verified according to IEC 60332-3-24.
Drop cable for indoor use, tight protected, 4.8 mm, TOL 406 3006+
The drop cable is primarily intended for direct installation, i.e. installation with staples or clips or routing inside cable raceways and moldings. It has therefore an extra thick cable sheath. The tight coated fibers allow easy splicing or connector assembly. Aramide yarns around the fibers guarantee the tensile performance. The fire resistance is verified according to IEC 60332-3-24.
Drop Cable for indoor and outdoor use, tight protected 4.8 mm, TOL 406 3007 Data sheet
This cable is similar to TL 406 3006+ but is intended for installation cases where sections of the cable is installed both indoor and outdoor. The fire resistance is verified according to IEC 60332-3-24.